Hey guys, I was wondering if there is a way to cut a mesh up using just the edge loop that's already on the mesh. This would have the same effect as select a couple of faces and doing Mesh - Extract, but this way round would take me ages because I have such a complex model.
Thank you to any one that can help me.
How about selecting the edge, doing a bevel with a very small offset. Then selecting that new loop of faces and deleting them. Select the model and seperate.
ReplyDeleteA quick and easy way to select those new faces is this :
ReplyDelete-Select your loop
-Bevel that loop with a small offset
-Insert an edge loop between those 2 new edges you have from the bevel
-Double click that middle edge loop
-Convert that selection to faces
-Delete
Like this :
ReplyDeletehttp://oi48.tinypic.com/4tajvl.jpg
:D
Thank you Jon
ReplyDelete